diff --git a/website/site/content/docs/configure/file-backends.md b/website/site/content/docs/configure/file-backends.md
index 899f8c7e..64dd3e0a 100644
--- a/website/site/content/docs/configure/file-backends.md
+++ b/website/site/content/docs/configure/file-backends.md
@@ -91,7 +91,7 @@ are presented above. The available storage types are
 
 If you use the docker setup, you can find the corresponding
 environment variables to the above config snippet
-[below](#environment-variables).
+[here](@/docs/configure/defaults.md#environment-variables).
 
 ### Change Backends
 
@@ -100,7 +100,7 @@ doing this, please make sure that the application is not used. It is
 important that no file is uploaded during the following steps.
 
 The [cli](@/docs/tools/cli.md) will be used, please set it up first
-and you need to enable the [admin endpoint](#admin-endpoint). Config
+and you need to enable the [admin endpoint](@admin-endpoint.md). Config
 changes mentioned here must be applied to all nodes - joex and
 restserver!
 
diff --git a/website/site/content/docs/configure/main.md b/website/site/content/docs/configure/main.md
index e2dc17d7..da5e16dc 100644
--- a/website/site/content/docs/configure/main.md
+++ b/website/site/content/docs/configure/main.md
@@ -28,7 +28,7 @@ At last, it is possible to configure docspell via environment
 variables if there is no config file supplied (if a config file *is*
 supplied, it is always preferred). Note that this approach is limited,
 as arrays are not supported. A list of environment variables can be
-found at the [end of this page](#environment-variables). The
+found at [here](@/docs/configure/defaults.md#environment-variables). The
 environment variable name follows the corresponding config key - where
 dots are replaced by underscores and dashes are replaced by two
 underscores. For example, the config key `docspell.server.app-name`